-
Hey,
I am using an ATTiny1634 QFN-20 package and am trying to read and flash it. However i am facing issues with reading the controller. I have tried using an Arduino Uno with ArduinoISP sketch as an…
-
Been playing around with the Series-1 uC using the TinyMegaCore from Spencer Konde
https://github.com/SpenceKonde/megaTinyCore
Pretty impressive next generation of chips with full SPI support an…
-
Hey,
I've been looking through the code to see if it is possible to run this code on an ATtiny (1614 for instance) and was curious if you had any input. I would love to run this code on an ATtiny w…
-
MCU: ATtiny3216
megaTiny library version: latest: 2.2.3
I need to change my approach on my project to use Pin Interrupts as show here;
https://github.com/SpenceKonde/megaTinyCore/blob/master/mega…
-
These will fix the R_AVR_13_PCREL error given when actual problem is out of space, the bad eeprom.h, and probably several other issues that we don't even know about yet.
-
#include
SoftwareSerial MySerial(PIN_PA4, PIN_PA5); // RX, TX
void setup() {
MySerial.begin(9600);
delay(100);
MySerial.println("Hello World");
After the first one or two lines printed …
-
This is more a couple of questions rather than an issue.
I am thinking of using a SiT1552 32.768 kHz MEMS as an external clock source.
Most specifically to implement a 3216 as an rtc with a screen.
…
-
The F() flash macro used for storing strings in flash memory no longer appears to be working as of the 1.8.5 version. The following error is reported during compile for each use.
error: cannot conv…
-
The macros below should be replaced by proper functions, or perhaps template functions for ultimate flexibility.
```c
#define min(a,b) ((a)(b)?(a):(b))
#define abs(x) ((x)>0?(x):-(x))
#define co…
-
Hello,
I would like to suggest that the uC Attiny85 bootloader be automatically burned before the sketch, when the upload is performed using the programmer.
This uC can operate with 1MHz, 4MHz, …