-
I have an http server project (not mine) and when I attempt to debug it with a breakpoint established I get
Failed to continue - no G executing on thread 0
If I start it with no breakpoints it st…
wcn00 updated
5 years ago
-
**systemd version the issue has been seen with**
> systemd 229
-PAM -AUDIT -SELINUX +IMA -APPARMOR +SMACK +SYSVINIT +UTMP -LIBCRYPTSETUP -GCRYPT +GNUTLS +ACL +XZ -LZ4 -SECCOMP +BLKID -ELFUTILS +KMOD…
-
Guys
Fport controls are working, but i recieve no telemtry or LUA script that get connection
I used the R-XSR Fport latest Firmware and used the small uninverterd pad on the R-xsr the Fortini f4…
-
PPM input not working on Airbot Nano v6 board.
Firmware used is FireworksV2.
PPM signal connected to SBUS pin, as suggested by Airbot.
Solution for Betaflight is:
Quote "teralift":
"Backdoor ti…
-
omnibus f7
INAV/OMNIBUSF7 1.8.0 Nov 1 2017 / 06:59:03 (912d1315)
ppm (pe13) does nothing.
also testing neo m8n + mag akm8975 on RX3 TX3 (sda scl) nothing gps half on RX6 TX6 works.
have photo o…
-
First time I used my Great Merchant to create customs, it simply disappeared:
H4sIAAAAAAAAANW9XZMjx7Gm+Vd65hoYq0x81x3ZkijNiBJH5DnaMRkv0NVQN5ZVhV6gilKJ1v99E8iI9McjPDI9UU3tWZOZWA0kMiMjPDz8433df7nb/7y…
-
With STM MCU, a transmission (TX) pin may be used as reception (RX) by configuring the corresponding U(S)ART unit to half-duplex mode. Betaflight does not support this mode for ESC telemetry inputs.
…
-
Dear Werner, yesterday night I noticed during some test on the board that the **passthrough mode** is influenced from max speed control pot, but not from acceleration pot.
If I switch to **Passthro…
-
I have a omnibus f4 pro v2 and a eachine tx5258 with smart audio, I don't get smartaudio to working, I connected on the smal solder pads ch5 6 near mcu and enabled soft serial, tryed uart 3 and 6 no c…
-
Thanks to @jflyper - we found that these FCs do only invert RX on UART6 with the definitions used in OMNIBUSF4SD. RX is controlled via PC8 (which is INVERTER_PIN_UART6 in the target definition). Inver…