-
I documented how I tested BLE Uart [here](https://forum.arduino.cc/t/ble-uart-works/1148164). An incorrect Service UUID is returned if the sketch is modified to add a servo. The modified sketch is sh…
-
With the current release (actually current code as well) as has been mentioned on a few threads now including:
https://forum.arduino.cc/t/serial-print-from-isr-will-hang/1145292
If you run a sketc…
-
On the Uno R4 WiFi, I'd like to make use of the Renesas' chips SCE (Secure Cryptography Engine). According to the .h file, the chip does that peripheral.
https://github.com/arduino/ArduinoCore-rene…
-
This issue tracks the porting of boards and SoCs to https://github.com/zephyrproject-rtos/zephyr/issues/51833.
### SoC series: AGILEX
- [x] soc: AGILEX
- [x] board: intel_socfpga_agilex_socdk, …
-
There's tons of "writing on the wall" that the ESP32-S3 on the Uno R4 WiFi board is loaded with a firmware that makes the device appear as 1. A USB CDC device for the serial bridge, 2. A CMSIS-DAP deb…
-
Would it be possible to make your library also work for the Arduino Wifi REV2?
-
I tested ver 0.1.6 using Giga R1 WiFi. Only a small change is required to make the examples work. I removed the check for ESP32 because Giga also uses WiFi.h.
Old
```
#elif defined(ESP32)
#inc…
-
I'm using an UNO R4 Minima together with a NXP TJA1051 CAN high speed transceiver at 500 kBaud.
**It's not possible to receive or transmit any CAN frames.**
The TJA1051 I've cross-checked in my …
-
Sometimes ModBus traffic fails with CRC errors after several hours of correct operation:
```
[W][modbus:109]: Modbus CRC Check failed! 8498!=10
[W][modbus:109]: Modbus CRC Check failed! 4F02!=10
…
-
Hi there,
In our prototyping with SARAR410 modules, we have very good progress in soldering these boards, but I am still having issues with the software. So going back to the basics, I am running …