-
### Version
Version 2.3.0+win64
### Operating system type + version
Edition Windows 10 Pro
Version 21H1
Installed on 16/06/2020
OS build 19043.964
Experience Windows Feature Experience Pac…
-
4.7.0
Win 10
The slicing engine seems to be struggling with circular perimeters. 99% of the code is fine, but there are random slowdowns during printing at 70 mm/s on a Duet Maestro, which should …
CCS86 updated
2 years ago
-
Are there any plans to put klipper in a docker format? I think running it off a pi running alpine linux would be a good idea rather than using octopi.
-
**Issue:** When on the home page (dashboard), tool info is reported as N/A. I've noticed this since upgrading web control from 3.2.2 to 3.3.0-rc3. When it does occur, it seems to come along with the f…
-
-
### Version
2.2.53
### Operating system type + version
Win10 x64
### 3D printer brand / version + firmware version (if known)
A Duet Wifi with RRF2
### Behavior
The print starts with homi…
-
Board: Duet 2 WiFi (2WiFi)
Firmware: RepRapFirmware for Duet 2 WiFi/Ethernet 3.2 (2021-01-05)
I have spent a few hours going through the documentation / wiki and reading through the gcode but cann…
-
### Version
2.3.2
### Operating system type + version
Linux Mint 20
### 3D printer brand / version + firmware version (if known)
custom built Rail core with a duet wifi
### Behavior…
-
Trying motors 0.9 and 1.8 degrees, a lot of variations of speed, sensitivity, homing speed, stealthchop adjustment. Latest version of the firmwares ( Duet Web Control 3.3.0-b2 RepRapFirmware for Duet …
-
Whenever I try to run heater tuning with M303, just as it's about to be complete, the printer resets and the tuning doesn't finish. Then if I run M303 it just says no heater has been tuned since star…