-
G0 rapid moves are shown as cuts when loading gcode created by other CAM software.
![image](https://cloud.githubusercontent.com/assets/1632746/26529418/894e1b44-438d-11e7-85cd-84c796251877.png)
…
-
-
i'm going to start adding shortcut letter combos to the DoctString of all Nodes... this process will take a while and will involve editing most nodes. I will use this pass to reformat some akward pyth…
-
Just like the first x & y moves to get the laser into position for an operation uses a G0, the same should be for the Z.
At the moment, the initial Z movement is a G1 which causes the laser to fire…
ghost updated
7 years ago
-
@chamnit : Just a few questions regarding where GRBL is heading if you can answer. These would obviously be questions regarding the ARM version as the UNO is maxed out.
1. Backlash Compensation - Sou…
109JB updated
7 years ago
-
I need to implement an "electronic leadscrew" mode on my lathe. I.e., I want the z-Motor to move at a constant speed until I stop it. To do so I want to set relative mode (G91), Feedrate and then cont…
-
@Stretop pointed out to me a bit ago that the crafting system is a little underdeveloped when it comes to gunsmithing. While you can assemble some stuff, all of the firearms you craft are at significa…
-
no , Hi @chamnit Feedrate override do not work with jog motions, but problem is happen, if the axis had move slow speed and travel is long(about 500mm) , i want to change fast speed , i only press sto…
-
Paraphrasing from a discussion with @wolfmanjm in Oct:
@wolfmanjm said
Maybe it is time to reconsider a special LW only command that sends a raster line at a time?
This will require some thought …
ghost updated
7 years ago
-
Just like most comment here this is not an issue but I like to get some input and give some feedback.
To play around a little bit I did mount a 2W blue laser+MOSFET to my ShapeOko+grbl and it is work…