-
There will have to be code written for the Arduino to collect the data from the sensors. This is just for the collection of the raw data and then the transfering to celcius.
-
Hallo Tom,
waere es moeglich, die Uebergabe der Helligkeit in mLux vorzunehmen, so dass auf der CCU (bis zu) drei Nachkommastellen bei der Lux-Angabe zur Verfuegung stehen? So koennte man die super…
-
Hi .
Im using ESP32 for the module. I want to connect it with wifi. however , on serial monitor it shows (connecting .............................) till forever. I wait for hours tho i believe it …
-
I know this error is a very basic one but I can't figure it out...
Your makefile is above my expertise too. Any ideas on this one? I'm trying to include a third party library. The error I get is:
…
-
adruino library manager is picky - the release number must match the library.properties file *and* the prop file must be updated *before* the release, otherwise stuff breaks. this happens often enough…
-
Maintainer: @commodo
Environment: lantiq_xway, r9414-2d139450a3)
Description:
python3-base conflicts with other python packages:
```
Collected errors:
* check_data_file_clashes: Package pyth…
-
Hello,
I rune muse 2.1.2-3, on Debian stretch. https://packages.debian.org/en/stretch/muse
When I start muse I get a message about the timer that is 250Hz while it must be 500Hz.
Muse fallba…
-
The library is listed in Arduinos library manager with an incorrect description
https://github.com/stevemarple/MLX90614/blob/e4d8505c4a75fb60ba175bb893ff92ea8092d272/library.properties#L6
-
Hi Steve,
I am using this library to run on LoLin NODEMCU (ESP8266) which doesn't have hardware I2C.
When I try to compile example SoftWire_MLX90614 file, i get following compilation error.
Ard…
-
The Wire.endTransmission() after the Wire.requestFrom() and the Wire.beginTransmission() before the Wire.requestFrom() can be removed in the next files:
- DIY-Thermocam/Firmware/Source/Hardware/Touch…