-
I have been having issues with the resource motor mapping on 3.1.0 RCExplorer target , I saw it was fixed in 3.1.2. However the mapping is not right IMO. I loaded 3.1.2 and the default mapping (from …
-
Hi and thanks for your port of Arduino to STM32f4. I've got it working and was wondering if i2s is available to get the stm32f4 discovery's audio codec working?
Thanks again.
Steve.S
-
Flashed OpenTX 2.2 and Betaflight 3.1 to try out live PID tuning. I noticed that the RSSI values displayed vai FrSky telemetry have changed significantly, Taranis reads RSSI = 1 when being close.
I…
-
This is not directly related with developers but I guess some might be interested so:
**What is needed to create a flying machine?**
- hardware parts and where to get them (a big issue for people in …
-
I try all versions from R1.6.4 up to R1.6.6.1 and in all of them after saving change in OSD next parameters in BetaFlight is reset to zero:
yaw_p_limit = 0
setpoint_relax_ratio = 0
dterm_setpoint_w…
-
I dont like to open new issue when i have a question so i decided to just make this.
my question what ENABLESTIX_TRESHOLD do when i change it up because i want ENABLESTIX a lot faster because its slo…
-
Hi,
Just got an official SP Racing F3 Evo flight controller and contribute to this great project.
I will use the board with :
- OSD (UART1)
- GPS (UART2)
- SBUS RX (UART3)
but where to plug Smart P…
-
Have a spracing f3, running newest inav but can't find G-tune. I'm new to quadcopters and this is my first one. How do I find it/enable it?
Best regards
-
flashed the 1.7.2 firmware to CC3D. and using mix tri ,the servo output is S3,but can not found s3 output on CC3D.
-
I think it's time to think about designing a FC specifically for INAV.
Features I want to have on this FC:
1. Future-proof design with an F4 (or even F7) CPU
2. 8 outputs supporting 8/0, 6/2, 2/6 mo…