-
### Answers checklist.
- [X] I have read the documentation [ESP-IDF Programming Guide](https://docs.espressif.com/projects/esp-idf/en/latest/) and the issue is not addressed there.
- [X] I have up…
hibfh updated
2 months ago
-
Can I connect a 5V power supply directly to the battery connector?
-
Ethernet with the Wiznet W5500 Ethernet Board
set up a static ip address and select ethernet instead of wifi in the webinterface
Says
tx_pin: GPIO4
rx_pin: GPIO14
So I edited the code to like this but cant seem …
-
Hello, I had a working TCAN485 board but I performed a "Full Clean" in Platform IO and now when I flash firmware I no longer have wifi. the Flash states it is successful. Is there a way of restoring t…
-
**Caution**
At the return point of ES_WIFI_HardResetModule
It requires the return value of `Obj->fops.IO_Init` (i. e. if it's set, `SPI_WIFI_Init`) as `ret >0`. However, when mode passed to `S…
-
### The problem
Since around 2024.04 two configured UARTs on a S2 Board will fail to boot.
It was working OK until 2024.03.
It is working with Arduino IDE
If either of the two UARTs is removed…
-
After installing all boards/libraries etc with new RPi OS upgrade everything works really smooth. The arduino IDE 1.8.19 runs well...
I can compile and upload for all my different boards except the U…
-
These are caused when the autorouter thinks it can't go forward from a point (it believes it must switch direction)
Make sure to read this article explaining how ijump autorouters work: https://blog.…