-
on the CPC, if you type `SOUND 1,1,500,15` you hear an high pitched note but actually it should be inaudible (it's a 62 kHz tone). Same if tone is 1,2,3... (any low numbered value).
I think this is…
-
I also need to access the following parameters:
spectral width (ideally in ppm but can work out the one in Hz)
transmitter frequency
Later, for bruker files I also need the following data
group delay…
-
While working on improvements of the code and testing it, I notice that some responses failed to be processed by evalresp 4.0.6 (original one), but they should. So this tiket lists responss which we s…
-
{
"Employer": "Law360 - LexisNexis",
"Labor Organization": "NewsGuild (TNG) - Communication Workers of America (CWA)",
"Local": "Law360 Union",
"Industry": "Information",
"Bargaining Unit Si…
-
There is currently no way of altering the values easily for staging, and as such a config file would be great to assist in testing and for future-proofing.
-
The documentation at https://docs.scipy.org/doc/scipy/reference/generated/scipy.signal.decimate.html says that the downsampling factor q has to be an integer, but it doesn't really draw any attentio…
-
The graphs on the GUI do not discard old data and they also display the data with all data-points. Furthermore, they do not look good with noisy data.
The graphs should have the following two prope…
-
I have to say, your work is fantastic. After testing, the results show that the decoding success rate is very high at SF7-SF10 and BW125-BW500. However, the results of SF11-12 and BW125-500 were not s…
-
I rotated my 1.8m dish from GK-2A HRIT over to FY-4A last weekend as it'd been a while since I had checked it. I attempted to get both FY-4A LRIT as well as HRIT. SNR looked good for both services, bu…
-
I am experiencing lag/stuttering and the occasional freeze especially at high sampling rates (the HackRF can go up to 20Mhz). I don't think there is a hardware issue as it is working just fine with ot…