-
@dagar Capturing this here.
I have had many issues with odd CI failures - that get resolved by one of the two following remedies:
A) Either restarting the CI or
B) deleting the cache and restarting …
-
Pololu's latest revision of this board is the v5 which combines ST’s LSM6DS33 3-axis gyroscope and 3-axis accelerometer and LIS3MDL 3-axis magnetometer.
I'd like to use your code this new revision. I…
k5njm updated
8 years ago
-
Hi
today I updated my firmware to 1.3.2. I used the source code, followed the guide http://dev.px4.io/starting-building.html and successfully built the project. After successful upload, my px4 got stu…
-
I just flashed master (f9df60919e4722edade53b066d25248af9d73fd6) to two different pixracer boards and I can't write top in nsh. I only get "2J" back.
Is anyone else experiencing this?
-
Please add our LSM6 and LIS3MDL libraries to the library manager:
https://github.com/pololu/lsm6-arduino
https://github.com/pololu/lis3mdl-arduino
Thanks.
-
On the latest master (dc1f343) HIL simulation with X-Plane stopped working compared to the master from a few weeks back. When I try to switch to mission mode it says: "Set mode command temporarily rej…
-
Prerequisite Issues: None
Followup Issues: TBD
Related Issues: None
### Summary
Research and determine if the autopilot would benefit from having magnetometer information. If so do further research a…
-
On **master** and **beta** branches minimum thrust is 0 if `mpc_mainthr_min`
-
cal] ERROR: Excessive offset for mag 0
[cal] calibration failed: mag
[PX4 sensor calibration txt.txt](https://github.com/PX4/Firmware/files/170794/PX4.sensor.calibration.txt.txt)
-
observed on bench while setting up for a test flight
https://drive.google.com/open?id=0Bw3digSMQXDuQjR1MHJTWDNnbGM