-
Hallo liebes Evcc Team,
Wir haben seit kurzem den **oben genannten Wechselrichter mit Pylontech Batteriespeicher**.
Seit gestern besitzen wir eine **go-eCharger Gemin v3**, damit ich evcc nutzen…
-
i have a pylontech battery and a DIY with daly bms. Both are connected to the raspberry via CAN.
I combine both with the battery aggregator. works fine
I would now like to use your seral driver …
-
Hi,
My inverter supports [Freedom Lite](https://www.freedomwon.co.za/) storage.
It seems to use similar protocol as PylonTech have.
Dynamic charging is supported and I can see the charging current …
-
the new controller firmware at pylontech setting does not report min and max cell voltage to the venus os
also no module temperatures
dvcc at the venus os does not work in pylontech mode.
victro…
-
I'm just setting up 48V lifepo4 with diymbs and Pip-MAX 8KW inverter/charger, which supports Pylontech bms/battery modules. I would like to add if possible BMS Pylontech support much as you have done …
-
### Contact Details
_No response_
### VRM portal ID
c0619ab2c843
### Country / region
Germany (de)
### B max
2.2
### TB max
1.2
### FB max
1.2
### TG max
0
### FG max
10
### Battery c…
-
Hi,
wanted to use this software under PI ( PI4...) but get stuck during installation.
Did you test it on windows?
>run 'python3 ./setup.py install'
I done
sudo python3 ./setup.py install
out…
-
I would also like to contribute something to this DIY project as I'm using it for my own DIY battery (48V 400Ah; 16S2P [one controller w/ 32 module boards]).
On the attached picture you can find a …
-
Good job, the decoding of the Pylontech Protocol
I am adapting the pylontech code for micropython.
Its running with the machine.UART
By the way, if you discard the first byte in the payload of …
-
Hi,
Tried few settings for inverter and found some trouble with them.
Goal was to prevent charging/discharging and how is it managed by inverter.
Prevent discharging did not actually stop battery d…