-
```
As soon as we click Settings|Configuration we lose the current port selection.
If a port opening fails, the error message is not correctly carried to the
user.
```
Original issue reported on co…
-
```
What steps will reproduce the problem?
1. Build PhantomX Hexapod.
2. Load PyPose and run the "NUKE editor".
3. Assign servos to the labeled locations.
4. Capture limits and neutral poses.
To e…
-
```
What steps will reproduce the problem?
1) Load a project into PyPose.
2) Go to the NUKE editor tool.
3) Click the 'Go' button next to Set/Test Signs.
What is the expected output? What do you se…
-
```
The Pose Editor cannot display more than 18 servos on most netbooks (it
runs out of space)
```
Original issue reported on code.google.com by `MFergs7@gmail.com` on 29 Sep 2009 at 4:08
-
```
1. Add an AX-S1 driver to the BioloidController Library.
2. Add an AX-S1 viewer to PyPose
```
Original issue reported on code.google.com by `MFergs7@gmail.com` on 6 Oct 2009 at 4:59
-
```
What steps will reproduce the problem?
1. Press "loop" button
2. Before loop is stopped, press loop again
3. PyPose hangs
```
Original issue reported on code.google.com by `MFergs7@gmail.com` on…
-
```
The EX-106 servo has a range of 12-bits, rather than 10, we need to do the
following:
# Allow PyPose to go up to 4095 for EX servos
# Select which servos are EX
# Adjust the radToServo() function…
-
```
What steps will reproduce the problem?
1. Build PhantomX Hexapod.
2. Load PyPose and run the "NUKE editor".
3. Assign servos to the labeled locations.
4. Capture limits and neutral poses.
To e…
-
```
The Pose Editor cannot display more than 18 servos on most netbooks (it
runs out of space)
```
Original issue reported on code.google.com by `MFergs7@gmail.com` on 29 Sep 2009 at 4:08
-
```
What steps will reproduce the problem?
1. Create a new pose
2. Give it a blank name
What is the expected output? What do you see instead?
Warning message should probably pop up, instead, all hell…