-
Hi Teams,
I realized that the minimum timestep parameters when using predictive solver can causes distortion under two cases:
1. Extreme low or high duty cycle
Assuming 5% duty or 95% duty on 2…
-
I tried to make settings for long-range, but with bw 31.25kHz, the message wasn't received. Also, I observed that with sf12 bw500kHz works to send and receive packet of data but with small length. If …
-
When running make test from the latest version, it didn't pass the whole suite of tests:
![image](https://github.com/srsran/srsRAN_4G/assets/8438920/b05c182b-7088-48ce-a074-21945dd6261d)
I'm usi…
-
Thanks for your unselfish work, it is great.
Tested all version , and it works on all mobile phone and recording devices, but I stumbled on device with chip ATJ2167 that have on board condenser mic…
-
I hate to open another issue for a question, but here goes:
Looking at trying to modify the PWM output of the variable spindle PWM to get close to 20kHz. The pre-scalars don't quite offer up what I…
-
Using a transmitter that is designed only for 25kHz channel spacing on a 12.5kHz channel would require a hardware splatter filter with the upper -3db point set so that the modulation parameters are in…
-
Hello,
you posed another milestone for this radio.. I've used for some hours today and to me it's a step forwared the fagci one!
I would just to note couple issues about:
- The AM fix seem not work…
-
Where can i buy nu25c16t? I rummaged through the entire Internet, I can not find anywhere. Where did you buy them?
-
Hello,
Finally took the time to install 1.0.6 with rotary encoder mod at 128Mhz.
I am really happy with the firmware so far. I also found some bugs I am reporting below:
1) In 5us mode (10kHz …
-
I was noticing my spectrograms looked like this out of the box:
![Screenshot_20240369](https://github.com/user-attachments/assets/95029a7c-e3bc-4383-b9da-fab7fe453dff)
My mic is the WAEM2 which …