-
Hi Dear Wolle!
Is it possible to allocate a separate pin for ESP32 S3 on which a high level would appear in sleep mode. I would like to use it to cut off the power supply to the audio power amplifier…
-
Hi everyone,
I found this topic about a possible way to send commands to LAcoustics amplifiers.
#276
This thread is closed and doesnt seem to be looked after.
Here are somme commands give…
-
I realized a transmitter based GNU radio and I can amplify the signal up to 3w using an amplifier. but with the portapack I can not. I tried to analyze the source code of the firmware havoc and I foun…
-
We have no problem running the EGIAmpServer connector, even two at the time since we have two EGI NetAmp 400 in a hyperscanning setup.
However, since both amplifier Id are set to the default value …
-
JLCPCB have neither the TPF133A nor the THS7316 3-channel 36 MHz video amplifiers.
They do have the [MS1681/](https://jlcpcb.com/partdetail/Hangzhou_RuimengTech-MS1681/C231920), which is a single-c…
-
We need to build a 10MHz amplifier delivering 10W of power to drive the RF resonator, which will boost it to 500V or so.
The amplifier will be 6HP wide and work with EEM and DI/OT.
The initial speci…
-
Just a quick question: is PyCorderPlus compatible with the original actiCHamp amplifiers? I see the drivers for the actiCHamp Plus are named just as "actiCHamp", so I'm hopeful that the answer is yes.…
-
Should also incorporate a 3-in 1-out mono mixer and run off +/-15v supply.
here's a circuit that uses NJM2073, which doesn't seem universally available
http://www.befaco.org/en/output-module-ii/
her…
-
Is it possible to set the open-loop gain and power rail voltage of an Op-Amp? If so, how is this done?
-
Hi,
348R || 0p8 between pin3(-) of subtracting amplifier and GND must not be there - it doesn't belong to a proper 1x subtracting amplifier circuit and it degrades CMRR.
I guess the bandwidth is…