-
Hello Terje,
Sorry to bother you.
I made some layout changes to your MPG DRO board, to make it a little more versatile (in my opinion), but the circuit is the same.
Among the various small modifica…
-
Hi,
I've been trying to set up my machine with the Trinamic TMC 5160 drivers that use SPI mode. Looking through this current implementation, it doesn't look like the SPI bus was implemented as a HA…
-
Either remove the pull-ups on the IN1 line on the motor controllers or add a pull-up to the IN2 line also. I actually recommend pull-ups on both, although removing is going to be simple to deal with i…
-
The `remoteIP()`function is available for [Ethernet UDP](http://energia.nu/reference/ethernet/ethernet_udpremoteip/) and [Wifi UDP](http://energia.nu/reference/wifi/wifi_wifiudpremoteip/) but not for …
-
The // remove the reset from the rf device code block results in the radio never being able to enter lp, (SPWD strobe fails)
-
Hi @terjeio , would it be possible to add plugin for Nextion displays ? [https://nextion.tech](https://nextion.tech)
I mean something like when you press a button it sends a Gcode command to serial.p…
-
_From @dronus on June 18, 2016 15:38_
If I use
`attachInterrupt(PUSH2,isr1,RISING);`
it works as intended.
If I however issue
`attachInterrupt(53,isr1,RISING);`
in setup(), the MCU crashes, loop(…
-
Hi @terjeio
Using ESP32 device with WebUI 3.0.0.a37.GH2
grblHAL firmware 1.1f-20230501
Device is ESP32 Wroom dev board
Using 4 axis WebUI is unable to parse data.
![ParsingError2](https://use…
-
### CLIENT'S REQUEST:
- It should run at the same runtime as the event.
- comes in the same theme as the event
- 3 sets each
release datum: 02.03.
Verbatim:
_Regarding the September Cashbook…
-
```
I'm using u8glib with Sharp Memory LCDs, which are monochrome but which use 1
for the "background" color and 0 for the "foreground" color. As far as I can
tell, u8glib expects the inverse to ho…