-
Hi,
recently i got watermeters from Qundis installed and stumbled over (https://github.com/zibous/ha-watermeter). But now i´m stuck with wmbus. it seems to be an error with decoding??
>[14:16:57…
-
I've had a look at the code. It should be possible to compile ESP8266 code to run the CC1101 directly, and have it provide a WiFi serial port for network access to the CC1101.
It would be a fairl…
-
### Description of the feature you're suggesting.
I have been looking for the right information but I am still lost. I am new to this. How do I know if the cc1101 module is working after hooking it u…
-
I am having troubles with wiring I believe
Stuck in boot loop
Due to the dual spi configs
I can not even boot when I have rx and d4 (I have code chip select for both cc1101 and tft on gpio 15 (D8) …
-
when i connect my esp32 via usb to my Laptop and the esp is connected to the CC1101 the esp gets really hot aswell as the CC1101 a little.
Any ideas?
(i triple checked the wiring)
-
If somebody could help me in set up connection between Arduino, CC1101 module and CCMANAGER software. What sketch should I upload ? Thanks in advance.
-
When attempting to run the minimal receiver example from the Arduino library for the CC1101 module, I encountered several compilation errors and warnings. These occurred in the ELECHOUSE_CC1101_SRC_DR…
-
Hi, I got a CC1101 usb dongle uart device.
I'm getting `ValueError: unexpected chip part number 255 (expected: 0)`
Can't be the wiring since its usb.
lsusb:
```
Bus 003 Device 004: ID 10c4:ea…
-
isPromiscuous implementation sets PreambleLen to 0 here
https://github.com/rfquack/RadioLib/blob/master/src/modules/CC1101/CC1101.cpp#L828
which is considered as invalid value
https://github.com/…
-
Just wondering if you have thought of porting rfcat to run on ESP32 and ESP8266, These processors are readily available and very inexpensive. Just add a CC1101 or a Nrf905.
Thanks
Joe