-
Would it be possible to add a Support for lead acid batteries on Deye Inverters?
The two main parameters battery voltage and current could be read from the inverter Modbus registers 587 and 591. This…
-
### Category
Other
### Hardware
Other
### Firmware Version
2.5.x
### Description
I'm seeing increased reports of "Solar station doesn't wake up after getting power". Guess we have…
-
I have attached an on/off switch. I'm unable to get the battery reading when the device is turned off and charging. Here is the behavior:
1) Not charging & turned on, IO4 reading is correct.
2) …
-
Place a battery charger in series with the control voltage supply and the returns. This will allow the battery to charge off of the current flow of the returned control voltage.
-
## Back Story
UEI EV charging implementation guide is created and sent review to Ravi. Hence closing this card. Review and Rework is tracking under this card in Sep16-29 iteration.
## Reference …
-
The application should also allow inline display of charge current (may be hard - parse from dmesg?) or at least bus voltage / charger type (is available in sysfs to be parsed easily).
-
Please include system details:
Hardware:
- 2x Battery with 18x 280Ah connected in parallel to Multiplus II
- Venus on RPi 3B+
- 2x JK BMS connected to the Pi via dbus-serialbattery driver
Se…
wetty updated
3 weeks ago
-
According to the docs describing the charging state, the final charging state should be `END_OF_CHARGE` or `DONE`.
https://github.com/arduino-libraries/Arduino_PowerManagement/blob/7ba266c0649e12f4…
-
I'm seeing fairly flaky behavior; info.py gets some info but then fails:
ReadDeviceInformationResponse(1)
Manufacturer: 'EPsolar Tech co., Ltd'
Model: 'Tracer4215BN'
Version: 'V0…
joeyh updated
1 month ago
-
The documentation recommend to set to 29.2v the voltage of the docking station.
When charging, the current is going through:
- D3 and D2 diodes
- R51 shunt
- Q6 mosfet
The total voltage drop …