-
if the config looks like this:
```
[JKBMS_UNTEN]
type=jkbms
protocol=jk04
port=C8:47:8C:E5:CC:9F
command=getCellData
outputs=screen
[JKBMS_BOX1_UNTEN]
type=jkbms
protocol=jkv11
port=C8…
-
Hi all, is it possible to use two Daly Smart BMS at the same time and send data to emoncms with different prefixes? Thank you
-
Hi,
my goal here is to gather information about the different BMS models sold under the Daly brand. We know that there are two different models around, the "normal" ones and the ones with "Sinowealth…
-
Add serial port definition ( ----Daly_BMS_UART bms(Serial2, 16, 17);--- )
Adding esp32 support
-
### The problem
HA is reporting an error related to the device class for remaining capacity in the daly_bms component because it is set to a device_class of voltage, but the units is Ah.
I dont thin…
-
### Describe the problem
Driver never connects to battery but does see the appropriate battery.
### Driver version
v1.3.20240705
### Venus OS device type
Raspberry Pi
### Venus OS version
v3.4…
-
### The problem
hi,
unfortunately the DALY_BMS component does not read my first 4 cells.
Installed are 16 cells, the values of the other cells come.
Can I write or read any logs with here?
…
-
Hi,
Thanks for your code, it's very helpful. Where did you find the doc to interact with the BMS through Bluetooth ? I was able to find that my Daly is using [this module](https://fccid.io/2AD56HLK…
-
**Describe the problem you have/What new integration you would like**
Add a way to enable/disable Charge and Discharge MOSFET status on the daly_bms integration. At the moment these are read only…
-
Do you have any advance in - "Pylon RS485 output" ?
My goal is to connect Daly BMS to PI device together with Growatt Inverter to the same PI device and send SoC from Daly to Growatt.