-
I want to add 2.5w ttl/pwm laser module to my corexy plotter.
https://goo.gl/images/2awCuV
1. What is the best method TTL or PWM?
2. What is the Wiring digram of TTL and PWM?
3. How to supply…
-
### The problem
Apologies for not catching the version this regressed in. I'm going to guess it was somewhere between 1.4 and 1.5.
We've lost the ability to disable and reorder the gcode tab …
-
"An error was detected while sending '$H': (ALARM:9) Homing fail. Could not find limit switch within search distances. Try increasing max travel, decreasing pull-off distance, or check wiring. Streami…
-
Hi,
actually I am fighting with the second step. LW4 is properly installed and is starting up at Debian 64 bit.
I can connect to my laser cutter via USB and can see in the log window of LW4:
…
df8oe updated
2 years ago
-
Hi ! I'm new to laser cutters and we have an old version of a Eleks Laser A3 ([EleksMana SE](https://wiki.eleksmaker.com/doku.php?id=eleksmana_se)) from Eleksmaker. I would like to know if I can use L…
-
Hello ,
I have my X-Axis motor Working
I have my Y-Axis motor working
I have a laser
https://www.ebay.com/itm/EleksMaker-445nm-7000mW-Blue-Laser-Module-TTL-PWM-For-Laser-Engraver-Machine-/11271081…
-
**Describe the bug**
I upgraded to the latest version of LaserGrble today.
Now when I open my image (13" wide x 10" tall) and tell it to find the center, it is not in the place it used to be (it…
-
Hey, I have this installed and am using an EleksMana board to control a laser engraver.
The issue I am having is that octopi with Better GRBL Support is feeding the gcode file way to fast and causi…
-
Hi
I followed the installation instructions on the website and installed the latest Raspian on a new Raspberry Pi 3. I also enabled Serial connection in the Raspberry Pi configuration. The webinterfa…
-
I have been using the plugin in a non-standard way. I set up some custom buttons for ZXY axis homing. I use octoprint to beam my .nc programs over to the pi. Then I use the custom buttons in the "cont…