-
I recently got a Pi5 and was hoping to set up these panels I have, but don't seem to be getting any LEDs to light up whatsoever.
I'm trying with a single 64x64 1/32 panel with a ICN2037BP chipset,…
-
Problem occurs after 1.75 patch
https://www.youtube.com/watch?v=58JG38k1joY&ab_channel=benjaminbaron
F5 cameras are making it fully emissiv
F7 only when we get close
this is as well changin…
-
Considering a project to use this with a CM4 on a CM4IO board. This has its own +12V to +5V buck for the CM4 itself, but not enough power for the LED panels. So the panels need to be powered separa…
-
****
## Current Behavior
LED strip stops working when load mixer on on iFlight BLITZ F435 after flashing firmware and mixer load.
LED strip is Chimera7 side panels
## Steps to Reproduce
…
-
as I put on the tittle I have the doutb if it can run 9 matrix (192 pixel h/w) its possible ? to make a square canvas for gift
the matrix will be chained (1,2,3,4,5,6,7,8,9) three rows and three col…
-
i was having some flickering issues with lines of pixels that have now been fixed with a more powerful power supply and new OS. im running diet pi and no longer get pixel flickering but i do get a ran…
-
Hello,
I recently purchased 5 of these modules from ebay ([https://www.ebay.de/itm/285579711444](https://www.ebay.de/itm/285579711444)) and I can only get one half of the display to light up when I…
-
I have a 1 daisy chain setup of (x9) 64x64 adafruit rgb led matrix panels, how can I make it happen?
The terminal tells me to make them ¨--led-chain=9 has to be divisible by 2¨, it displays a bad …
-
use the data from the doorway sensors to trigger lights on the led panels. Pixels create a pattern that looks "natural" when people enter room A and " technological" when people enter room B
Would ha…
-
sir i am trying to make a panel with 4x5 with 80X40 led p6 matrix on raspberry pi pico
this is my settings
#define DISPLAYS_ACROSS 4
#define DISPLAYS_DOWN 5
DMD_RGB_SHIFTREG_ABC dmd(mux_list, DMD…