-
## Here are the steps I follow to reproduce the issue:
There is currently no easy install process for the Gentoo Linux distribution. It can be built on Gentoo manually by following a set of instruc…
-
Please correct me if i'm wrong but it doesn't seem like there is any consideration between encoder position-scale and encoder-scale. From my research:
position_scale should be the machine units pe…
-
When I go to launch the app after installing on LinuxCNC 2.7 it just launches and goes away really quickly. However, after creating a launcher via the Desktop and selecting the file in `/usr/bin/cammi…
-
Dear Mr. Ittner,
Thank you very much for the great work!
I would like to report a problem which occurs while building the packagage using dpkg-buildpackage command. The problem seems to be relat…
-
Hi,
I have a doubt about this lib. I am not sure if it is a issue.
I after build and run, it seems it works.
I tested whit this Diagnostic Utility.
http://yyao.ca/projects/ParallelPortLinux/
…
-
Just a friendly FYI, `bcm2835` is GPL-v3 licensed and the copyleft clause requires that derivative work (e.g. everything under the `LinuxCNC/Components/Remora` folder) is also released under GPL-v3.
…
-
### Expected behavior
Error free compile
### Observed behavior
```
> rli@linuxcnctest:~/LibreCAD$ git checkout tags/2.1.3
> Note: checking out 'tags/2.1.3'.
> ...
> rli@linuxcnctest:~/Libre…
effad updated
11 months ago
-
As @rene-dev mentioned to me it is currently not possible to run tests in parallel, mainly because there can only be one linuxcnc instance running at a time. After investigating for a bit and looking …
rmu75 updated
8 months ago
-
Allow for Encoders to be attached to the controller (pin dependant) and provide low latency feedback to LinuxCNC host without impacting motion control.
Test and validate LinuxCNC controlled closed …
-
Encoder should update counts ( int64 would be nice) as well as send velocity units so that G96 can work.
remora has encoders as does linuxcnc-rio for reference.
PCNT could be used but it is limi…