-
.. instead of immediately wake up.
It works fine withe DEBUINO == 1
-
Hello everyone, I am working with the Lora 32u4ll of BsFrance and a gateway kernel, it works, transmits to Yeap (a lora provider) but the RSSI is very low, around -117 and my lora 32u4ll is very close…
-
I am currently testing a new node-to-node communication form, LORA direct. (no WAN)
@TD-er
I am suggesting the following data structures:
```
struct Lora_SysInfoStruct
{
byte header = 255;…
-
It seems that there is a limit of 128 bytes in message + redundancy when using this library on AVR (in my case, LoRa32u4). It would be nice to point out in documentation that library does work on AVR …
-
Hi,
I'm testing with the LoRa32u4 II board. The node joins fine to the TTN network, sends the first payload, but then never sends again, as EV_TXCOMPLETE is never called.
-
When sending in a room no more than 2 meters apart, i get a RSSI of around 70. In the backyard through a couple of walls and 20 meters tops a RSSI of 105.
I wanted to make this better, but i don't …
-
I'm successfully using two Lora32u4 II boards with the default send/receive examples.
However, calling setSpreadingFactor with 9, 10, 11 or 12 hangs (haven't tried the other values).
```
#include…
-
It's will be good to add +20 dBm mode for SX1276 board and written in manual http://www.semtech.com/images/datasheet/sx1276.pdf
```
see 5.4.3. High Power +20 dBm Operation
```
I have 2 boards: htt…
-
Good day
I am using a LoRa32U4 device from BSFrance and I get a Starting LoRa failed! response. I have looked through the various issues and have attempted to get the version using:
uint8_t ver…
-
I have an AI-Thinker RA-02 (SX1278) on a LoRa32u4 board, which won't initialise. I've tried multiple modules and checked the pins are correct using `LoRa.setPins()`
How can I debug why it's not wor…