-
```
Maybe this issue is too vague to register as a "defect" but as there is no
discussion forum for CSipSimple, here goes:
I was using Sipdroid for a while, but I strongly dislike their UI decisions…
-
```
Maybe this issue is too vague to register as a "defect" but as there is no
discussion forum for CSipSimple, here goes:
I was using Sipdroid for a while, but I strongly dislike their UI decisions…
-
## Description
While switching the test tool, I discovered several tests that fail due to curand failure. The tests seem to fail randomly. So far it involves: `test_operator.py::test_batchnorm`, `t…
-
Radio 0 after selecting radio number, then pressing T; getting a core panic.
Board is a Doit ESP32 Devkit V1; using Arduino IDE
`SPI pin defines:
MOSI 23
MISO 19
SCK …
-
This is a continuation of #619.
With the release of Luma3DS 8.0 and the custom sysmodule Rosalina, we have been getting a lot of issues concerning Rosalina's current/planned features, as well as r…
ghost updated
3 months ago
-
**Is your feature request related to a problem? Please describe.**
Je ne peux pas ajouter mes thermostats individuellement dans Énergie. Étrangement je peux ajouter mes switchs de Hilo que j'ai conne…
-
Hi, I have a new device who works strangely, All seems good, but the led on the device stay red (go off on normal full commissioning) and on deconz it go to yellow then red.
It's a device from the ne…
-
Thanks to authors for the work on this project.
For background, I am using smartwatts in combination with hwpc-sensor in an attempt to monitor the power consumption of relatively short jobs, with s…
-
**Describe the bug**
AlDente does not block the load at 80%. In fact, after installation, I let my 2018 MBP 15 discharge below 80% and then plug it back in, some time later it is at 100%. I also have…
-
**Describe the bug**
Seem to have a format problem. According to sensor.energy_consumption my heatpump has an daily energy consumption > 100 kWh. Whereas between 10 and 25 is appropriate. (sensor sen…