-
hi everyone i have just bought my raspberry pico and i wanted to try and learn how to program a microcontroler and i didnt like the thonny ide(and couldnt get it to install micropython on my board) an…
-
I have a PID algorithm written on TIVA C TM4C123GH6PM launcpad. I want to setup a PIL simulation with Simulink. Simulink will send the error signal to TIVA, the PID will calculate the control signal a…
-
-
##### SUMMARY
For some devices like AVR microcontrolers, each pin have multiple functionalities and as many names. For devices with a lot of pins, it is a real problem.
The other problem is that com…
-
Please make a hardware to insert pocket operator there that connects to 10 pin on the back, ill write a software
-
please create a plugin to connect mach3 CNC to bCNC.
-
After using Serial1 in Sketch it is not possible to upload a new Sketch anymore
-
Hi,
This is a thread to share and discuss together our experiment and vision about modular tools for roboticists as planned with @vmayoral.
# Who am I ?
I'm CEO at Luos robotics: www.luos-robot…
-
Hi, i can't figure out how to declare pin for tx and rx, i can find only the DE/RE pin
Can you explain?
Thanks!
Alessandro
-
I don't want to re-invent the wheel if it already exists, but I started putting one together last night. And I would like to offer it for use in the primary project, given the popularity of firmata if…