-
I am an automatic service that looks for possible errors in ioBroker and creates an issue for it. The link below leads directly to the test:
https://adapter-check.iobroker.in/?q=https://raw.githubu…
-
I have flashed this firmware to a nodeMCU and did the initial configuration to connect it to my wifi network. OTGW data is now accessible over port 25238 (using openHab BTW). Only issue I have is that…
-
Hello there,
Now is possible to add MQTT set command for the OTGW command 'COOL' (ID 000:HB2: Master status: Cooling enable). This is the command for enabling the cooling on the heatpump.
Thanks…
-
Looks like the description of the **hotwater** settopic value is incorrect here:
https://github.com/rvdbreemen/OTGW-firmware/wiki/Using-the-MQTT-set-commands
Instead of :
`temp = [number e.g. 20.…
-
To improve security of the OTGW, I have some suggestions that might help.
- Fix issue #131
Go for a "simple" solution, like pressing the Wemos D1 reset button on powerup, create a initial flash w…
-
Hello @hvxl,
OTGWMCU doesn't reconnect to Wi-Fi if I reboot the router. I either have to connect to its AP and restart it or power cycle it.
Would it be possible to either make it reconnect to W…
-
Hi,
I am very new to github so not sure if this is the right way to go about things.
I have modified my copies the scripts to allow setting of the maximum modulation (MM=) and max central heating …
-
Hi,
I successfully flashed v3.0.14-g963ffbb on an Amica NodeMCU (4Mb), and the wifi connection went smooth, it all seemed to work correctly. I've connected it to a Opentherm Gateway (in case anybody …
-
Robert first of all great work on this software. Did you thought about expanding it with integration to Blynk ?
-
Some websocket servers require the origin header to be sent, or else a 404 is returned and the node remains "Disconnected". The origin header is normally set by the webbrowser. This behaviour can be v…
ghost updated
6 years ago