-
I've been using your pico-usb-io-board firmware for a few days, mostly to make I2C components accessible from within linux. This works really convenient, thank you for making & publishing this.
I f…
-
Great set. However: Just soldered with a beginner and it turns out that the paint on the circuit board is a bit thin. A short circuit can quickly occur at three points where plus and minus are close t…
-
In general, the connectors of the micro:bit are a bit "hard"
The copper pattern, 4 holes and 1.25 stripes need to be a standard component to be cherry picked.
Connectors, 80 1.25 are quite often not…
-
-
Could you please upload the 3D file in STEP format of the entire ESP-POE Rev. L? Thank you very much.
-
Where do i get the main PCB and all the other parts that are marked as ‚Included in required components set,?
thx btw great work so far!
-
Design a UHF (e.g. 70cm) PCB for use with a DRA818U chip, the main challenge will be figuring out how to filter spurious emissions (need to see if components with values that low are available and/or …
-
Hi
I'm about to order assembled PCB:s from JLPCB and used the files from this repo without any modification. However several components are on the "preview" turned 90 deg and the USB connector is sl…
-
### Is there an existing issue for this?
- [X] I have searched the existing issues
### Problem description
Hi,
i have a imported STEP assembly with originally slightly over 1000 components. I cl…
-
Between the spacer dimensions in `Mechanical/Small/Module/c1_design_space_ref.pdf` and the PCB limit area dimensions in `Mechanical/Small/PCB/c1_pcb_concept_design_ref.pdf` there appears to be an "off…