-
On M4 feather Express, I get a REPL output of
```
code.py output:
Traceback (most recent call last):
File "code.py", line 34, in
ValueError: D11 in use
```
My Circuitpython Code is :
``…
-
Both these sensors have a `SET` pin that when pulled `LOW` puts the internal controller to sleep mode but it doesn't turn of the fan. Also sadly the DFRobot breakout PCB ties this to `HIGH` all the ti…
-
Has onboard / plug-in PicoW which has GP8/9 hooked up for UART to the optional PMS5003. See schematic here: https://cdn.shopify.com/s/files/1/0174/1800/files/pico_enviro_pack_schematic.pdf?v=166496482…
tyeth updated
7 months ago
-
If I use pm01basic sketch it works fine. But if I move read procedure out of void loop(void) to new readPMS() function I receiving CRC Error quite often. Even more: after 10 - 15 minutes I receiving …
-
Hello my friend
I have a project that i use pms5003
Also i use gps,mq131,mq7 and LED 64*128
I CONNECT VCC of pms5003 wire to 5v esp3 and connect gnd to gnd
Then connect rx and tx of pms to tx an…
-
hi,
i not able to install the node. i get this error message.
18 Dec 12:17:43 - [info] Installiertes Modul: node-red-contrib-easybotics-air-quality
18 Dec 12:17:43 - [info] Hinzugefügte Node-Ty…
-
We need the wider dimension of the PCB to exactly match the PMS5003 PM sensor. We'll need to shave off about 1-2mm, but check.
We also need to remove the corners of the PCB so screws can go through…
-
I've got both a MHZ-19 CO2 sensor (connected to A6 using PWM mode) and a PMS5003 particulate sensor (connected via UART) on the same expansion board.
![IMG_3716](https://github.com/skotopes/flipperze…
-
This is the sensors and components wish list:
~~- [x] MQ2 (limited lifetime, comsumes too much power, needs calibration)~~
~~- [x] MQ135 (limited lifetime, comsumes too much power needs calibratio…
-
Hi, RigacciOrg. I installed the AirPi following Software setup step in website.
It can read the data from BME280 (I don't get PMS5003 yet). But when I open the web interface, the "Display" site isn'…