-
I ordered two ratgdos last fall. I installed both and both were working correctly. I recently noticed that neither were showing up in Apple HomeKit (I had installed the native HomeKit firmware.) When …
-
I am using the ratgdo 2.53 with security 1 garage door opener. I am using the mqtt with mosty good results, however I am running into the same issue every 3-4 months. I can't seem to figure out what's…
-
Could the configured control mode be added to the discovery payload? Perhaps something like:
```
{
"~": "ratgdo-41533",
"name": "Door",
...
"device": {
"name": "ratgdo-41533",
"i…
-
I previously opened an issue under MQTT when I had that installed w/r/t random issues with my Sec 1.0 opener. See [https://github.com/ratgdo/mqtt-ratgdo/issues/65] for background on the issues I had w…
-
Hi folks,
Quick Details:
Hardware: ratgdo 2.52i
Firmware: 2.56 (Current), Also tried 2.57
GDO: **Overhead Door Odyssey 1000**
GDO Control Protocol: Sec2 and Sec1
Overall my issue seems ver…
-
I have a 2.5i board and had issues connecting to 2.4ghz channel on my router. I had to set it to legacy mode to get it to connect. Because this board uses an esp8266 chip, I did some research and foun…
-
TL;DR : ratgdo hardware and web UI work with 100% success, but HomeKit integration fails with 0% success.
OK, I have tried many times to figure this out with no success yet. It’s been rather frust…
-
After power outages for my jackshaft 1.0+ door openers, my doors enter an uncontrollable state where they open randomly until the ratgdo is restarted. I have tested this with MQTT and ESPHOME firmwar…
-
Hello all.
I got a RATGDO v2.5 board and flashed it with ESPHome using the [official web flash tool](https://ratgdo.github.io/esphome-ratgdo/). I selected "Security + 2.0" + "ratgdo v2.5x".
Then…
-
When first migrated from the MQTT version to ESPHome, the button entity was "off". The first time I pressed it, it changed to "on" where it's been ever since then, persisting through reboots.
I'm u…