-
Description
Trying to get the link up in 100G mode for the LR4 interfaces on 400G ports.
Same links were up against ARISTA QSFP28.
setup detail:
Fortigate 3810D CFP2-LR4 port1 --------------…
-
-
Do we have prometheus metrics export support to capture pmacct metrics
-
**Description**
**Steps to reproduce the issue:**
1. Run nightly test cases
2. Check failures
**Describe the results you received:**
```
self =
setup = {'acl_table_ports': ['Ethern…
-
#### Description
During LAG testing was found following problem:
Sometimes **snmpd** randomly throw message "`ERR snmp#snmpd[21]: Failed to open /proc/net/dev_snmp6/PortChannelXXX`" after LAG r…
-
Why can Sflow-RT and Tcpdump obtain sflow data, but sflowtool cannot obtain sflow data?
-
Hi, thank you for your great open source. Then I found a question unable to get the answer on docs, like the following list:
1. How do I set the sampling rate to 100% (or 1-in-N)? because I used the …
-
Ok, trying to play with the mib_paths.
My questions are as follows:
1. Am I doing something wrong? Other then bruteforce doing more then I need to?
2. Should Failed Loading DIC's stop the pipel…
-
**Description**
After the PFC storm is restored over a designated queue, the port still drops packets for that queue.
**Steps to reproduce the issue:**
1. Start `pfcwd` with default confi…
-
### Use Case
sflow-RT and tcpdump obtain the sflow data of port 6343. However, telegraf could not obtain sflow data. And the telegraf configuration is fine.
[[inputs.sflow]]
service_address …