-
Would it be possible to add the homing per axis for TinyG (g2core) firmware. Just check it and homing per axis on g2core works the same way as it does in Marlin and Repetier.
-
With a working 1W custom ESP32/LoRa board now (thanks to you & Bob-N6RFM!), I noticed that the default tinyGS "Power" parameter (5 dbm) did not take advantage of this device's power output capability.…
-
I'm running into a problem where when I send Gcode to a TinyG V9 (Bantam/Othermill) using ChiliPepper and SPJS, and there are small steps in the Gcode (specifically that of a small arc around the tear…
-
We are getting many reports from users having difficulty setting parameters to new values and making them usable - experience is, for example changing $1tr = 33 to $1tr = 40 is only effective after a…
-
The m5stack board is not in the supported board list, but I tested and compiled, uploaded TinyGS, with PlatformIO, in my m5stack board, with module LoRa 433, crossing my fingers that it works :). Comp…
-
Hi there,
I noticed in the source the tinyg object initializes a 'RTSCTS' default but I'm not clear on how to actually use this flow control in an application. Also, in the tinyg documentation it …
-
Tinyg V8, Zmotor is normally reversed. Running touchplate widget causes motor to move up instead of down.
-
Running firmware 412.01..
Connected tgfx to my tinyg v8 that I had previously setup via coolterm and had configured for "inch" mode.. Once tgfx/tinyg connected I checked all the settings..
All axis/m…
-
I'm running into a problem where when I send Gcode to a TinyG V9 (Othermill) using ChiliPepper and SPJS, and there are small steps in the Gcode (specifically that of a small arc around the teardrop of…
-
I cannot find any other way to contact anyone. Might be a dumb question but following the instructions it tells me to join a group on "telegraph". Go there, click on the "Join" and nothing happens?? I…