-
### Description
The driver configuration for the X, Y and Z axes of the Alfawise U30pro is set to A4988 (lines 570, 571, 572) but the printer have TMC2208 drivers.
I think must be some of kind TMC…
-
Compiling with VS code and PlatformIO
I set the
-----------(platformio.ini)
[env:mks_robin2]
platform = ststm32@5.4.3
-----------(configuration.h)
#define Y_DRIVER_TYPE TMC2208
then I …
-
Just a quick question on the TMC2208 driver support in Remora. Does Remora use the step/direction pins for stepping and direction even when a UART RX line is enabled for the TMC2208?
-
Hi !
I can control my axes but when i'm asking for a homing (G28) they move about 1 cm and stop.
Here the answer of my terminal :
Send: G28
Recv: X:0.00 Y:0.00 Z:0.00 E:0.00 Count X:0 Y:0 Z:0
Rec…
-
While testing some stepper I noticed that they became rather hot even if the TMC2208 was configured with a conservative rms current using `rms_current(uint16_t mA, float mult)`
Checking current con…
-
I would like to set up my Bigtreetech SKR v1.3 with TMC2208 drivers to use Z1 and E1 steppers to control my two Z motors to take advantage of Z motor leveling in Marlin 2.0. Can you do this and does a…
-
TMC2208 X connection... Error: All LOW
But same Stepper will work in Y,Z or E. So Stepper ok.
X will work with TMC2130 in SPI mode or TMC in Standalone mode. Think it may be the X-UART jumper pi…
-
Does this config file actually work?
The klipper FAQ has a section
[My TMC motor driver turns off in the middle of a print ](https://mmone.github.io/klipper/FAQ.html#my-tmc-motor-driver-turns-off-…
-
![erro last version github](https://user-images.githubusercontent.com/77403096/105249498-f6270700-5b56-11eb-9b0e-078ef0c2c781.PNG)
![Erro TMC2208](https://user-images.githubusercontent.com/77403096…
-
Hey guys, lately on my SKR V1.1 Pro board, I've been getting this strange `coil short circuit` error with my TMC2208 drivers (which are on my Extruder and Z axis). I've gone and checked the wiring and…