-
There is something about these MACROS that causes Sensorless Homing to consistently fail. It is always on the second AXIS.
If Y is first than X will not HOME.
If X is first than Y will not HOME…
-
Hello,
I managed to get my stepper motor to work with my TMC5160 and Arduino Uno via FastAccelStepper.
I try the same thing but this time with an esp32 devkitc v4. But no way to get there.
So…
-
Hello all,
I am remarkably new to this world and have been struggling trying to get this to work. I am using a Teensy 4.1 and a [TMC5160 BOB v1.2](https://www.trinamic.com/fileadmin/assets/Products…
-
Hallo
Im trying to use the XTARGET and the motion controller to control my stepper motor.
teemuatlut posted an example for the exakt same problem.
https://github.com/teemuatlut/TMCStepper/iss…
-
**TL;DR: This code works on Arduino Nano, but doesnt work on STM32F103C8T6. Motor just does nothing, no locking, no rotation. Software SPI works fine, STEP/DIR worsk fine, wiring is fine, motor is fin…
-
Hi
I wasn't quite sure where to post this (whether in the Marlin or in this repo), is Stallguard/Sensorless homing currently working with the TMC5160 or is this yet to be implemented?
I'm asking b…
-
0x6F for DRV_STATUS in datasheet shows 3 flags missing from the inherited TMC2130 struct. For TMC5160 should have the following that includes s2vsa, s2vsb, stealth instead of the reserved 5 bits.
…
-
I have the same motherboard and was looking at your VS code. First question is does it work? I don't have a sensor mounted yet nor do I want filament run-out yet. Something stuck out that you have E2 …
-
I want to do sensorless homing in my project. But not able to how to do using this library.
Thank you.
-
Hi, first of all thank you very much for your work.
This is more a question than an issue. It is about the velocity of TMC5160 which I did not fully understand it.
In the datasheet, the unit of the…