-
Hi,
Currently developing board based on tmc2160, losed tmc5160 because it pointless without supporting encoder feedback on marlin side. So, to reduce amount of wire i decided to make uart-spi bridge,…
-
On Windows 10 systems using the latest (11.2.0.167) CP210X driver I can not connect to ESP32 devices with a Silicon Labs CP2102 or CP2104 USB to UART bridge. I receive `Error: Timeout`
PlatformIO or…
-
Hi @malcolmmackay, your project seems very interesting to me and I wanted to ask if we can use any generic USB to UART bridge (FT232R/CH340/CP2104/PL2303) for programming the MSP430 with your programm…
-
Hello!
I was wondering if this core can be used out of the box as USB-UART bridge. Do you think it's possible to generate a DTR and a RTS signals? Essencially I want to use the ECP5 to act like a USB…
-
I'm currently working on an ESP32-WROOM-32E and I'm trying to integrate the iot_bridge module so that I can control a 4G modem via the UART.
I'd like to be able to configure pin 34 for the RX of t…
-
### The problem
I purchased a WeiKai [WK2168 breakout from AlieExpress](https://www.aliexpress.com/item/1005007605743585.html?spm=a2g0o.order_list.order_list_main.11.51921802UtddRR) and it has not be…
-
Hi.
I'm trying to backup the firmware in my BK7231N device (the Wi-Fi switch with CB2S module).
I have soldered 5 wires - GND, VCC, RX, TX, CEN.
I have provided 3V3 VCC and 3V3 UART I/O voltag…
-
### Steps To Reproduce
Steps to reproduce the behavior:
1. build *linux-rt_latest*
### Build log
```
$ nix-build -A linux-rt_latest
these 2 derivations will be built:
/nix/store/4ja466m…
-
```
The UART bridge mode might include an option for automatic baud detection
if the target device's baud rate is unknown.
When the baud rate is unknown the bus pirate can look at a few incoming
char…
-
```
The UART bridge mode might include an option for automatic baud detection
if the target device's baud rate is unknown.
When the baud rate is unknown the bus pirate can look at a few incoming
char…