-
Before opening a new issue, please make sure you've reviewed the troubleshooting guide:
https://github.com/brimdata/brimcap/wiki/Troubleshooting
**Describe the bug**
Failed to upload pcap with wi…
-
## Basic information
- Board URL (official): http://www.orangepi.org/html/hardWare/co…
-
### Describe the bug
I swapped over to the new secretsFile spec for wifi secrets (as per @rnhmjoj). I've put the diff for the config below. `net1` has special characters in the password and connect…
-
I am somewhat concerned with power consumption given that each sensor seems to consume around 4-6mA. I wonder if it would be possible to turn on hall effect sensors cluster-by-cluster while polling. M…
-
apt-get install kismet
Reading package lists... Done
Building dependency tree... Done
Reading state information... Done
Some packages could not be installed. This may mean that you have
requested…
-
The ATMEL D2x series MCU seems like a good candidate for the MySensors MCU core because it is equipped with up to 256KB of on-board flash for program memory and 32KB RAM for data - the increased flash…
-
We're planing to mass produce the PCB board, found four BOM files. Which files to be used? Please add more comments, or remove unused files.
-
I'm using this library to listen to my remote, but I can't get a single code, the output is always different:
(this is a long press)
```
2019-12-19 23:17:34 - [INFO] receive: Listening for cod…
-
Sebastiano,
So there's two types of motes currently implemented in sdn-wise-contiki
1. Compiled C Motes for emulated hardware (sky etc.)
2. Java motes.
I have two questions:
1. Is it pos…
-
Hi,
I used Raspberry Pi 3 A+ over Honda Jazz Digipad 2.0 and based on steps mentioned under readme file, and was able to connect it successfully. Tried calls and it works, also tried google assista…