-
Hi I am trying to analyze the timestamp returned by the IQ capture program. I use the MATLAB script 'test_iq_file_display.m' to analyze the saved 'iq.txt' file and visualize the timestamps. However, a…
gxhen updated
2 years ago
-
FTM protocal is used for ranging, details can be found here:https://www.researchgate.net/publication/328327674_Verification_Accuracy_Evaluation_of_WiFi_Fine_Time_Measurements_on_an_Open_Platform.
I j…
-
1.How can I set the protocol type of 802.11? At present, hw_mode in the conf file can only support 802.11a/g, and 802.11n will be displayed as undefined.
2.At the same time, if I want to set the 802…
-
I built the Linux img from scratch, burned it on SD card and finally when I am running post_config.sh I have this:
```
root@analog:~# cd ~/openwifi && ./post_config.sh
++ uname -m
+ MACHINE_TYPE…
-
Hello,
I am trying to simulate 2 projects separately, the 'openofdm_tx' and the 'openofdm_rx' modules in Vivado 2018.3. I wanted to run some tests for the legacy type packets. So I have a file that…
-
Hello,
I wanted to verify the direct TX1A to RX1A wireless link. I am sending a stream of repeated data on the 'dac_data' bus (modified the 'tx_intf' module and added the ILAs on 'dac_data' and 'ad…
-
0. Hello, I have 2 separate sets of 'ADRV9361-Z7035 + ADRV1CRR-BOB' boards that has working openwifi. I wanted to use one of the boards as it is with running openwifi (host board) and the other board …
-
From Eugene Liu:
Hi, I am looking to do some experiments with SDR using openwifi on Analog Device adrv9364z7020 hardware. I am first grade master student and new to this device. Mainly t…
-
we used z7020 custom board.
I set an Zynq board as an AP by hostapd, the hostapd-openwifi.conf is as follows:
--------------------------------------------------------------------------------
interf…
-
Hello,
0. I am working with the boards 'ADRV9361-Z7035 + ADRV1CRR-BOB' and was successfully able to create 'openwifi' SSID, connect to it and load the local host page through phone. I am now trying…