-
```
Making some time to do more BETA testing (finally!)
What steps will reproduce the problem?
1. Set Beep-Cntr on for REa and/or REb
2. Enter DIAG screen as an additional visual aid (watch counters)…
-
Tried a lot of things, but whatever I do in BLHeli or BFC always ends up with all motors spinning at quite low rpm, even in disarmed state or failsafe.
- LB Pro ESCs flashed to 1020-1980us PPM, center…
-
```
Making some time to do more BETA testing (finally!)
What steps will reproduce the problem?
1. Set Beep-Cntr on for REa and/or REb
2. Enter DIAG screen as an additional visual aid (watch counters)…
-
```
Making some time to do more BETA testing (finally!)
What steps will reproduce the problem?
1. Set Beep-Cntr on for REa and/or REb
2. Enter DIAG screen as an additional visual aid (watch counters)…
-
Hey Folks,
The problem does not happen every time I way hard, but after about a minute of trying to invoke the problem it will happen. It looks like when I yaw left or right, one of the motors loses…
-
When I turn my TX off Failsafe Stage 1 gets triggered and works perfect but no matter what I do Failsafe Stage 2 never engages. I tried making a "Failsafe" mode switch and I still cant get Stage 2 to …
-
I'm running NAZE 2.9.1 firmware. I powered my quad with the arm switch in the active position. No problem. The motors did not spin. I had to toggle the arm switch on the transmitter to get the mot…
-
Target: PIKOBLX
Betaflight version: 3.0.0 RC12
Go to CLI:
set telemetry_inversion = OFF
save
Go back to CLI
get telemetry_inversion shows ON
Dump:
# version
# BetaFlight/PIKOBLX 3.0.0 Aug 27 20…
-
Quad performs a mode-dependent frontflip or backoff on takeoff. In angle or horizon mode, I get a backflip. Raising throttle slowly, in horizon or angle mode, front motors go very high as soon as craf…
-
Hi Boris, I tried betaflight 3.0 on my Sparky 2 board and I experienced some weirdess:
1) When I set an arm mode, the position marker moves as if it would arm but the bit on the left in configurator d…