-
I have purchased 2 spider 1.0 boards, both having the same 3.3v issue with stepper drivers plugged in. Initially, I could not figure out why the SD would not flash with a firmware.bin in the root dire…
-
I have an issue with a stepper driver from StepperOnline (DM542T). Im 99% sure that it is related to the "setAutoEnable" and the timing delay set by the "setDelayToEnable".
The spec sheet for the s…
-
Hi.
I've just finished the mechanical and electrical build for a large OX-CNC from Makerstore.
We are running arduino uno, GRBL0.0j, CNC shield v3.0 with TB6600 stepper drivers and adapter cables to…
-
In the project wiki, the list of stuff you need has bad links. The servo/stepper hybrid motor and the motor driver are dead links. Could you either post updated links or enough specs on both so I ca…
-
Marlin/src/module/stepper/trinamic.h:29:10: fatal error: TMCStepper.h: No such file or directory
in the ENV is the lib disabled. How can ich compile it with tmc driver support?
BR Hexxter
-
* How does shopbot connect to it's limit switches? Bonus: Are there any connection points near the stepper drivers?
* Are they normally closed or normally open?
* Do we need to feed them power via t…
-
Has anyone else had this problem? I had everything all set up and it was working and just about ready to install on my lathe (Craftex 701). I was checking out the different feed rates and threading…
-
I just received the board, installed the firmware, installed correct pins and installed DVR8825 drivers but I get no movement from the stepper motors, not even a slight resistance when turned by hand.…
-
Need a viable replacement since those motors are no longer an option.
-
I received an email asking about TMC2209 drivers in UART mode. I thought it best to move the conversation to a more public space so that the collective wisdom of the open source community can be harne…