-
I was wondering if this was possible, but I would like to have some sort of conditional bed leveling implemented.
What I mean buy this is for anything 3cm in diameter and smaller, I do not need my…
-
### Did you test the latest release build?
Yes, and the problem still exists.
### Bug Description
After a period of time the homing feed rate will increase dramatically from a cold start. Only by …
-
```
What steps will reproduce the problem?
1. Class('CA', {
has: {
PROPERTY: {init: {}}
},
methods: {
initialize: function(){
this.PROPERTY.TEST = "inited by " …
-
### Description
The stock start gcode for the Taz 6 includes the G26 to "clear potential 'probe fail' condition". It appears Marlin now uses it to validate the bed leveling mesh.
### Steps to…
-
Assalamualaikum sir, how are you?
we need to intrigrate zatca 2nd phase qr in our program , can you help us?
![IMG_20220602_112641](https://user-images.githubusercontent.com/44413298/171646757-d…
-
Since there is a Marlin command to output current loaded Mesh into GCode backup ( Gcode to enter to bring mesh back).
Would be nice if Bed Visualiser could have that option, to save it to file and …
-
Do you have plans to enable the speaker and replace the buzzer in any of your releases?
my current install only has one tone
super excited for the m300 command..
-
### Did you test with a precompiled firmware?
Yes, and the problem still exists.
### Bug Description
Tenho uma ENDER 3 V2 NEO, funcionamento perfeito, nunca tive problemas, porém resolvi de atualiz…
-
When I compile I get an error on the serial communication:
I already changed the serial3 to serial2 on nexconfig.h. Nextion board is connected to serial 2 on ramps (pin 16 and 17).
Is this fork st…
-
When using UBL without a LCD with an encoder wheel, you must manually enter the commands to go to each spot to fine tune the probing. I propose a toggle switch that enables and disables automatically …