-
Hi.
I've just finished the mechanical and electrical build for a large OX-CNC from Makerstore.
We are running arduino uno, GRBL0.0j, CNC shield v3.0 with TB6600 stepper drivers and adapter cables to…
-
Hi João, thank you for the great project.
I have two focusers running 2a on an UNO and controlled by INDI Moonlite DRO driver in EKOS, Kstars.
During focusing, the focuser will randomly jump bac…
-
We have a problem to control the Polar coaster v2.
The X axis works, but if we give a command to the Y axis it doesn't work.
Also the Z axis from the servo motor isn't working.
First we changed…
-
Hi,
I've got a 2130 connected to an adafruit arduino(bluefruit LE). I've changed the various pins(en, cs, dir, step) to ones on the board and have(it has dedicated pins) MOSI -> SDI, MISO -> SDO, S…
-
I installed the latest marling bugfix 2.0.x firmware, made all the necesary modifications to config and config_adv, just testing the board with the steppers, nothing else. sending m122 gives this resp…
-
It is very unclear that you MUST use the CAN connector to power the board and cannot use the HVIN + USB connectors alone.
For future readers, here's how the various connectors work for real-world u…
-
### Did you test the latest `bugfix-2.1.x` code?
Yes, and the problem still exists.
### Bug Description
There is different, strange motion sound with FTM enabled (without IS). See also https:…
-
I bought anBIGTREETECH SKR V1.3 to replace my old board, which died of extruder failure (stopped driving the stepper), and I'm trying to make sure it is properly configured before connecting to my ha…
-
When I built my Vz330, after setting up the motors as specified in the docs under
[VzBot 330 - Mellow Kit -> 6. Electronics -> 6.8 Mellow Fly Super 8 1.3 -> 5160 Motor Setup](https://docs.vzbot.org…
-
I use the tmc2660 stepper driver on my 3D printer. I use the TM2626Stepper library. When I start my 3-D printer, it is warming up because the motors come to a standstill and how do I stop it at the …