-
I've been working on F7 (and stm cube hal driver) support. I now reached a point to catch up with the master. I'll have to do some work on the merge so that might be a good opportunity to fix some u…
-
After one our on a large experiment (>350 nodes), the following nodes are not responding:
```
-----------timeout--------------m3-220
-----------timeout--------------m3-1
-----------timeout-----------…
-
The layout you suggest for installation is incorrect. It _WAS_ correct for the older versions of Arduino. 1.6 and beyond lays things out in a much better way.
Here is how I did the installation:
under…
-
Hello, whenever I try to run the Makefile I get this...
%% startup_stm32f10x_md_gcc.S
make: arm-none-eabi-gcc: No such file or directory
make: **\* [obj/main/NAZE/startup_stm32f10x_md_gcc.o] Error 1…
-
-
-
在bsp/stm32f10x/drivers/bxcan.c中
static const rt_uint32_t bxcan_baud_rate_tab[] =
{
// 48 M
MK_BKCAN_BAUD(CAN_SJW_2tq, CAN_BS1_12tq, CAN_BS2_3tq, 3),
MK_BKCAN_BAUD(CAN_SJW_2tq, CAN_BS1_6tq,…
-
Most library example code uses includes of the form: #include "LibraryName/LibraryName.h"
This is also the form that the web IDE uses when it adds a library for you:
// This #include statement was au…
-
0、硬件上蓝牙需要连接的是串口rx、tx、复位引脚。串口是115200波特率。复位需要拉低引脚,延时,拉高引脚,完成复位
1、原始代码有一处错,蓝牙复位引脚初始化。led.c文件下31行GPIO_InitStructure.GPIO_Mode = GPIO_Mode_Out_OD;应该改为 GPIO_InitStructure.GPIO_Mode = GPIO_Mode_Out_PP; 在stm…
-
```
Edwin P. reported the problem and the solution:
http://old.nabble.com/-Bug-gas-13215--New%3A-ARM-Cortex-M3-strexh-strexb-instruc
tions-with-same-registers-generates-error-td32516436.html
```
O…