-
Tom, N4FWD, has requested an output volume control for driving his radio from FreeDV:
> there is no "volume" control for the transmit output of
> FreeDV. That shortcoming would be mitigated if Fr…
-
From Mike, G4ABP:
Matt, G6WPJ, has also observed a bug when 2020 is selected, and you switch to analog to transmit SSB. We don't switch to SSB very often, so no one else had observed this. I have h…
-
Configure FreeDV with a radio and headset (two card configuration):
1. With all USB devices connected click on Start and FreeDV runs OK
1. Press Stop and remove one USB device
1. Click on Start and…
-
https://github.com/drowe67/freedv-gui/pull/64#issuecomment-667903077
-
On 800XA the Scatter plot (which runs in Eye diagram mode) is flat when tested with [this]() off air signal. This may have been caused by some recent maintenance of the scatter diagram code in https:…
-
When I've got CubicSDR 0.2.5 running, but have selected "Stop/Start Device" in the menu to stop (pause) the currently running SDR, CubicSDR still has high CPU usage. Here's what it shows for me on Ubu…
-
FreeDV1.5.1 source code
Using fedora cross-compilation
Create an executable program for Windows
Install on Windows 10
When I try to run it, I get an error and cannot run it
The error message is a…
-
Go-Back-N needed for high performance transmission
Stop-And-Wait could be interesting for low SNR transmission
DJ2LS updated
3 years ago
-
Per Siegfried Jackstien from the digitalvoice list, FreeDV should have a way to support PTT with foot switches, etc. (via CTS pin on serial port?)
-
It is not possible to control a radios frequency/VFO's via CAT control.
I think that 4 Steps up and down in Khz from these frequencies as required by the bandwidth of the selected mode with reason…