-
So to understand it correct it is not possible to just insert the MKS WiFi Module in the connector, so have to router RX / TX direct to the board? How well is this working with ESP3D? Know Luo had so…
-
What hardware would you recommend someone to buy for Z-Stack 3.x Zigbee coordinator firmware?
- https://github.com/Koenkk/Z-Stack-firmware/tree/master/coordinator
Personally I am low on funds ri…
Hedda updated
4 years ago
-
### Describe the bug
I am using a Revolution Pi Connect S, which is based on CM4-S. I have flashed a bootloader config to enable BCM-USB-MSD boot. With bootloader versions up to `pieeprom-2024-04-1…
-
Is it possible to use a multiprotocol firmware with the ZB-GW03?
"The Silicon Labs EFR32MG21 based Zigbee SiP radio module it uses is the exact same “SM-011 V1.0” modules and Zigbee firmware by [Co…
-
When following the readme I can not program the bl602.
`cargo blflash --port /dev/ttyUSB0` ends up in a bunch of `rust-lld: error: undefined symbol: `. I suspect I might not have something installe…
-
### Machine Context
The main goal is:
to have the possibility to upload job files using Ethernet (not WiFi because of interference issues and long distances) and start them on grbl_esp32. The mach…
-
### Development Kit
LuatOS ESP32-C3
### Module or chip used
ESP32c3
### Debug Adapter
directly connected USB
### OpenOCD version
v0.12.0-esp32-20240726 (2024-07-26-15:19)
### Operating System
…
-
I'm aware that others have reported these kind of issues and that investigations led to various possible solutions. However, I'm not clear as to what the current recommendation(s) are with regard to …
-
Hi,
Sorry for opening a second issue during the same day, but I'm facing another weird issue when using Labview (this time natively on Linux). Basically, if I write data and right afterwards read t…
-
Hiya,
am getting an issue where i can't seem to get opencd to work on a gd32e505re.
This is the error message:
```
Building in release mode
Checking size .pio\build\genericGD32E505RE\firmware.…