-
I followed the new instructions to use external temperature sensor, works great, but i believe it extremely important to add to instructions that if you are using a HA sensor and your HA is set to u…
-
Hello,
I am running S2 Mini board (but tried with WROOM-32 and it was the same) and from time to time the board goes offline and after a while it reboots. Here is the log from the WEB GUI:
[17:36:…
-
this is more of a feature request
(if it doesn't exist already):
Beside future hours, I'd like to take into account x past hours.
So to have a reference window starting from somewhere before, not o…
-
**Describe the problem you have/What new integration you would like**
I would like to have Gree AC with YAY1F1 remote to be supported for IR Remote Climate.
None of these available models work…
-
### Feedback
Dear all,
I´m running the Nibe Heatpump integration on a Raspberry Pi4 together with a Lilygo ESP32. Downstream there is a conventional F model of the SMO40 and a F2120-16 heatpump. It …
-
As described in https://github.com/NREL/openstudio-standards/pull/1820, these two lines will need to change to be able to use the next version of openstudio-standards (version 0.7.0).
openstudio-lo…
-
Hi, i think i have a new feature request. I have an evohome setup with a heatpump that supports heating and cooling. Basically my heatpump is controlled by 2 BRD91T1004. One for the normal demand, and…
-
Hi,
My default settings look a lot different then described in this topic:
` {serial}`
` **0**`
` **mqtt.biodom27.si**`
` **8884**`
` %somehash/id%`
` %somehash/password%`
` .\Res…
-
I have four units (3xMSZ-HR25VF and 1xMSZ-HR50VF) and I have been running the integrations from both geoffdavis and echavet on a Wemos D1 mini for a couple of weeks before switching to this one.
Fo…
-
In heating mode, if I have the tolerance set to 1F and the precision to 0.1F, and the setpoint to 68F, it turns on at 66.9F, but turns off right away when it gets to 67.1F. I would expect it to turn o…