-
Howdy,
I flew RC3 in a wing today and while the flight timer worked this time, the GPS coords in the OSD were missing and also I noticed that in cruise mode, the rudder stick had no output on the m…
-
Background http reporting does not work when the app is killed.
It does work in a way for starters, but then it gets stuck.
For this test I have used the 'cordova-background-geolocation-SampleApp'…
ghost updated
6 years ago
-
### Board and Version
INAV/MATEKF722 1.9.1 Apr 21 2018 / 13:43:00 (03a5c1922)
# resources
# mixer
mixer QUADX
mmix reset
# servo mix
smix reset
# servo
servo 0 1000 2000 1500 100 …
-
## Current Behavior
With Launch Mode permanently enabled, if launch mode is aborted and you launch manually, the Fly timer will not start (Using On TIme / Fly Time OSD element).
If you launch usin…
-
On latest Release stable release 3.1.7 accel is not picked up on configurator, tried an earlier firmware with same result. Tried a much earlier release 3.0.1 with success.
Looked back through code a…
-
Currently the list of choices for gyro_lpf include "OFF" and "EXPERIMENTAL". In the code, the list of choices is intended to let the user set the cut point of the hardware LPF in the gyro; it then se…
-
I tried to update my RTFQ Flip32 F3 OSD board from Cleanflight 1.12 to 1.14.2 on my RTFQ Flip32 F3 OSD board. Old Version in CLI said SPRACINGF3 so that is the firmware I installed. Flashing seemed to…
-
Any plans for Sparky 2 support in the future? Sparky 1.0 already done.
-
I'm using F35 with MPU9250 sensor in fw 1.9, after finish 6 steps, my board can not level.
When i use FF_WING fw 1.8 and do calib in 6 step, it worked great, board can level. Can you help me c…
-
@martinbudden @gke After seeing many reports of YSTTM reports beginning to appear in the rcgroups thread I retested BF 3.2.1 on my yaw spin rig and found that the slew filter that deals with gyro over…