-
Hi, I have been running this repo using the MIT mode for AK 2.1 firmware motors. There were some small glitches but everything worked fine. I now switch to the servo mode. But it seems the current rep…
-
### Cura Version
5.6.0
### Operating System
windows 11
### Printer
Creality ender 3 S1
### Name abnormal settings
I only rotate the part on 30 degrees
### Describe model location
no
### Desc…
-
Connected to a Futaba S3305 servo, the servo diddn't move. We connected an oscilloscope to the pin and found that there was no signal being sent on the pin. Through a little trial and error we figured…
-
Servo recently switched to Ubuntu 22.04 for the nightly builds, which meant that binary links against glibc 2.34. This has [broken](https://github.com/web-platform-tests/wpt/runs/18833574018) the task…
-
One of the goals of the University of Szeged team in this year is to implement the WebGPU API (https://gpuweb.github.io/gpuweb/) in Servo.
This includes the following tasks:
- [x] Set up a backgroun…
-
It happens, that some servos or other motor controllers require the PWM signal to be outputted at a specific frequency. These frequency my be between 5 and 400 Hz.
It would be awesome to configure t…
-
-
Hey,
Really excited about this tool. I tried to get it to run, but it just crashes servo on launch. Servo builds and runs runs fine. Here's the errors, it's varying between 4 & 11. It just briefly sh…
-
```
What steps will reproduce the problem?
1. Use NanoWii (Atmega32u4) in tricopter mode
What is the expected output? What do you see instead?
Right after I plug in the battery the servo goes crazy a…
-
```
What steps will reproduce the problem?
1. Use NanoWii (Atmega32u4) in tricopter mode
What is the expected output? What do you see instead?
Right after I plug in the battery the servo goes crazy a…