-
**_Reported by Dhamodharan Krishnan:_**
Would be great if we can add support for Nucleo-L0 boards as it supports very low power application.
NUCLEO-L073RZ
NUCLEO-L053R8
(Imported from Jira ZEP-2…
-
### Board
LOLIN S2 mini
### Device Description
LOLIN S2 mini with ESP32-S2FH4 chip
### Hardware Configuration
LOLIN S2 mini with some buttons attached to IO pins, connected to a Windows…
-
Hi,
I encountered a small issue with trying to use the stm32g030 series (cortex M0+ mainstream line) which seem to not be present in platformio? They are supported by cube and stm32duino as far as …
-
Hi,
I'm trying to set an interrupt based on detecting a RISING edge using the BLE33. However, the pin reads HIGH after startup. Same happens with `pinMode(buttonPin, INPUT_PULLDOWN)` followed by `a…
-
When following the example in readme.md [Load an update sketch](https://github.com/arduino/mcuboot-arduino-stm32h7?tab=readme-ov-file#load-an-update-sketch) for OPTA device from Finder, the upload get…
-
It looks like these methos are only used in the AVR ports, and even then they indicate that they should not be used.
[ArduinoCore-avr/libraries/SPI/src/SPI.h#L306-L310](https://github.com/arduino/A…
-
Your code reads
https://github.com/davetcc/TaskManagerIO/blob/2840e53c91f4184497180c27c8bbafc851fdc10c/src/TaskManagerIO.cpp#L410-L412
However, this throws the error message
```
.pio\libde…
-
https://mbed.org/
For devices like http://www.seeedstudio.com/depot/Arch-GPRS-V2-p-2026.html
-
Hi
I am designing a custom board based on the nRF52XX mcu, where I am planning to use the Arduino IDE to upload sketches. During the development process, versions having different versions of the m…
-
File ArduinoCore-mbed/variants/PORTENTA_H7_M4/pins_arduino.h
The digital pin definitions for the pins D16 through D21 appear to be incorrect, and result in an error when used in code. These pins c…