-
Greetings,
I'm using 1.0 and seeing some missing entries, double entries, and entries that are marked as failed prints.
I've attached history.db and history.bak. For good measure, I also includ…
-
Hi everyone! I am very new to all of this and decided to install the BTT SKR mini E3 v1.2 board in my ender 3 pro. After install of the new board, my printer will not auto home. I think the X Y end-st…
-
any chance we get a fork of the mmu3 firmware and i think 3.13 for the mk3s+ and mk4 support?
i was hoping to get rid of my mk3s+ and move it over to the mk4 i started looking at the firmware and s…
-
Win64, but I don't think that matters. When using spiral vase mode, it appears that slic3r is using the cooling parameters of "min_print_speed" and "slowdown_below_layer_time", resulting in a print s…
-
Upon my first poor experiences with my new 3D printer I was keen on improving my results. My analysis showed me one topic, which I have analysed a little bit deeper: the applied flow math.
Within the …
hoh61 updated
6 years ago
-
Dear All,
Some of the component links dont work (especially this one 1x Objective lens, No Name, 100x, NA1.25, 50 Euro, China ) in the Infinity Florescence Microscope page:
https://github.com/…
-
1. Myosins (we’ll have antibodies and tagged myosins for students to use in the lab)
2. Forkhead transcription factors, including RFX. We are currently generating antibodies against RFX proteins, but…
-
The Harmonic Drives used in current Dexter versions are difficult to source, expensive and may have issues with backlash due to side loads. Cycloidal Drives hold great promise: It may even be possible…
-
Is it possible to have a version of 5 x PTFE tubing holder that takes M5 threaded brass inserts (for Festo QSM-M5-4 Pneumatic). These I already have, whereas I would have to order in the M6 or M10 si…
-
**Application version**
4.4.1
**Platform**
Windows 10/64 bit
**Printer**
Custom setup for E3D tool changer
**Reproduction steps**
1. 4 extruder setup, using extruder 1 and 3
2. Enabled …