-
Hi,
Currently, I'm working on custom firmware for the (two) sensor boards. In its current status, it has been tested working on one of the sensor boards (reading the MPU6050 and sending data over s…
-
Wroom-32
Chip is ESP32D0WDQ6 (revision 1)
>rst:0x5 (DEEPSLEEP_RESET),boot:0x13 (SPI_FAST_FLASH_BOOT)
>flash read err, 1000
>ets_main.c 371
>ets Jun 8 2016 00:22:57
```cpp
#include "esp_deep…
-
EMAC driver attempts to manipulate PHY registers unconditionally. It become a problem, if switch (like ksz8863rll) used instead of regular PHY. It's desirable to introduce CONFIG_ parameter to do avoi…
-
Wroom-32
> rst:0x5 (DEEPSLEEP_RESET),boot:0x13 (SPI_FAST_FLASH_BOOT)
> flash read err, 1000
> ets_main.c 371
> ets Jun 8 2016 00:22:57
```cpp
#include "esp_deep_sleep.h"
#include
#include…
-
After the latest changes in the bootloader component, some SPI Flash chips cannot be set to **QIO mode.**
**Gigadevice GD25Q32 (ID: 0xc84016)**
```
D (41) qio_mode: Probing for QIO mode enable...…
-
Is it possible to include the field weakening code from https://github.com/larsmm/hoverboard-firmware-hack-bbcar to increase the top speed of the hoverboard.
Because this projects re-integrates th…
-
### Steps to reproduce
Flash a fresh esp-01 module (black) with any 1MB bin
Does the problem presist after powering off and on? (just resetting isnt enough sometimes)
yes
### Expected behavior…
-
I checked the GigaDevice GD25Q32C datasheet: it supports QIO r/w ops. The board schema shows 4 data lines connected with mcu. But the bootloader doesn't enable the QIO mode.
In /components/bootload…
mfp20 updated
6 years ago
-
Nicola Corna told me that he has a draft commit which would implement switching off the Intel ME for a generation 1 ME as it has my Penryn based system (Q9100 with my FTS Celsius H265/H270). Up to no…
-
When I try to flash a SST26VF032 from microchip/SST, esptool gets a timeout when trying to connect and flashing is not possible (A fatal error occurred: Failed to connect to ESP8266).
I use a SST26VF…