-
If you look at a cisco acl list, it is common to have an acl like:
rule 5 permit ip source 1.2.3.4 0.0.0.0
or in some cases:
rule 5 permit ip source 1.2.3.4 0
here both 0.0.0.0 and 0 are cisco acl …
-
**Describe the bug and expected behavior**
I have two Cisco IOS router configurations. Router R1 is in AS 400 and router R2 is in AS 512. R1 sends a route 100.0.0.0/8 to R2 after setting the local pr…
-
They are IOS-like, but differ in that you may specify CIDR prefixes for addresses, and that the "ip access-list/no ip access-list" syntax is like Cisco's "ip access-list extended", but without the ext…
-
found on a 4500 vss switch that its possible to have multiple temperature sensors with the same name in snmp...causes confusion with attaching events to components (unverified) and over-riding templat…
-
For some fields they may have a `type` of `empty`. These fields do not necessarily have a value, and are represented that way in MDT. Need to determine how to treat - a boolean? What should the defaul…
-
Hi,
Is it possible to deny commands after entering conf mode on cisco? Does do_auth.ini allow this?
So far i can use "command_deny" only for "conf term" and not for commands available in config mode.
…
-
Understand ASR1000-RP2 CPLD and FPGA Upgrade Common Issues - Cisco
-
### Description of Issue/Question
*Note*: Please check https://guides.github.com/features/mastering-markdown/
to see how to properly format your request.
### Setup
### Netmiko version
(Past…
-
### Summary
When using aws_s3_bucket_info with a supplied bucket name to determine the bucket location, an unnecessary ListBuckets call means that more permissions are needed than what is needed to…
mohag updated
4 months ago
-
Hi folks,
We've detected an error that the JAGW returns the wrong telemetry data.
The following is short documentation to explain the problem adequately.
In our network, we only stream informa…