-
### Description
Homing is done with a nozzle temp of 120° and the bed temp from the G-Code (in my Case 80°). After Homing the line on the left side is "printed" with 120° nozzle temp. Then it heats…
-
### Description
Same as issue #7 , but with latest release available. After aborting and then starting the print again, it goes on flawlessly.
#### Additional Information
Using start/end gc…
-
### Description
Bed level (mesh) data is not used after power cycle.
### Steps to Reproduce
*If this is a Bug Report, please describe the steps needed to reproduce the issue*
1. Flash firm…
-
**Describe the bug**
When I ran a x86 windows dotnet malware with qiling, it showed "Error: PC(0x0) Unreachable". I printed out the instruction using `hook_code`. It seemed to be crashed in `mscoree.…
-
Per the [replacement wordlist][0], the following wording needs replacing:
```
./charm/metadata.yaml: interface: nrpe-external-master
./config/config.go: // TODO whitelist only some hosts (HostP…
-
Installed the plugin today to test on my CR6 SE - default firmware (v1.02), but the temperature output did not change.
Things tried:
- Disconnect and reconnect to printer
- Restart Octoprint serv…
-
### Description
Since this printer is very quiet, adding a little sound at the end of the gcode it's a nice touch.
I tried building the firmware with _#define SPEAKER_ enabled in _configuration.h_…
-
As the UI becomes enhanced with new configuration functions like esteps, PID, Retract/Restore, etc.., Users who do not use their USB serial interfaces are going to have increasing need to be able to s…
-
### Bug Description
When printing g-code from the touch screen, if there is a G29 command right after the G28 command, it causes ABL to fail and for the hot end to fly off to one side and grind the…
-
The test URL (https://idprotect.vip.symantec.com/testtoken.v) has been taken down. Every call now says the "token is invalid", though the tokens are fine if I comment out that code.
It looks like t…